Subaru Forester

1997-2005 of release

Repair and car operation



Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
- The power supply system and release
   Specifications
   System of release of the fulfilled gases - the general information
   Measurement of pressure of fuel
   Pressure dump in the power supply system
   Principle of action and check of serviceability of functioning of the fuel pump
   Service of the fuel filter
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Service перекидного the valve
   Removal and installation of the case of a throttle
   Injectors of injection of fuel - the general information and service
   Regulator of pressure of fuel - the general data
   Cleaning and repair of a fuel tank - the general data
   Removal and installation of the gauge of measurement of weight of air (MAF)
   Check of serviceability of functioning of system of electronic injection
   Turbo-supercharging system - the general information
   Service of system of a turbo-supercharging
   Release system - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
3df4be34


Measurement of pressure of fuel

Before a manometre detachment necessarily dump pressure in system (see Has undressed pressure Dump in the power supply system).

Remember that gasoline is extremely an inflammable liquid! At work with power supply system components observe all taken measures of fire safety.

Do not smoke! Do not come nearer to a place of work with open fire or the redurable not protected by a lamp shade!

Do not make system service in the premises equipped working on natural gas and heating devices equipped with a control torch (such as водогреи and dryers for clothes).

Do not forget that gasoline is among cancerogenic substances, i.e., - the substances promoting development of a cancer!

Try not to suppose fuel hit on open sites of a body, use rubber protective gloves, at casual unforeseen contact to fuel carefully wash out hands warm water with soap.

Immediately collect the spilt fuel and do not put the rags impregnated with PETROLEUM PRODUCTS near to sources of open fire.

Remember that the power supply system equipped with injection of fuel of models constantly is under pressure.

Before to start a detachment of fuel lines, dump residual pressure in system. At service of components of the power supply system put on goggles.

Constantly hold near at hand the class fire extinguisher In!


 PERFORMANCE ORDER

1. Dump pressure in the power supply system (see Has undressed pressure Dump in the power supply system).
2. Uncover a jellied mouth of a fuel tank.
3. Disconnect gasoline pipe lines from the fuel filter and connect a manometre for measurement of pressure of fuel.
4. Connect electroconducting to the fuel pump.
5. Start the engine.
6. Consider the manometre indication at the vacuum hose disconnected from the inlet pipeline. If the result of measurement falls outside the limits an admissible range (235 265 кПа), replace a regulator of pressure of fuel in gathering with the vacuum hose connected to it.
7. Restore initial connection of a vacuum hose and repeat measurement. Compare считанное the indication to requirements of Specifications (177 206 кПа). At negative result of check replace a regulator in gathering with a vacuum hose.