Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
- Coupling, трансмиссионная a line
Specifications
Coupling - the general information and check of a condition of components
Removal, check of a condition of components and installation of the main cylinder of coupling
Removal and installation of the executive cylinder of coupling
Removal of air from a hydraulic path of a drive of deenergizing of coupling
Forward power shafts - the general information
Removal, service and installation of forward power shafts
Removal and installation of assemblage of a rotary fist, service ступичной assemblages
Back power shafts - the general information
Removal, service and installation of back power shafts
Removal, service and installation of a back nave
Back differential - the general information
Removal and installation карданного a shaft
Removal and installation of a flange of a leading gear wheel of differential and epiploon
Removal and installation of back differential
Differential major repairs
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Coupling, трансмиссионная a line
The general information
The present Chapter is devoted трансмиссионным to the components located between a back part of the engine and driving wheels of the car (including back differential, however without a transmission and a distributing box which are considered in the Head a gear change Box according to the destination considered components it is possible to break into three categories: coupling, карданный a shaft, semiaxes/power shafts and back differential. In below-mentioned Sections descriptions of a design and a principle of action of each of separate knots, and also some procedures of check of a condition, removal, dismantling and the regenerative repair, components entering into all three groups are resulted.
As the most part of procedures described in the present Chapter is made under the car, it is necessary to give special attention to reliability of fixing of the last in the lifted position.
|
|
