Subaru Forester

1997-2005 of release

Repair and car operation



Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures
   Check of serviceability of functioning of system of ignition
   Assemblage of coils of ignition - the general information, check of a condition and replacement
   Check and adjustment of installation of a corner of an advancing of ignition
   Replacement of the module of ignition
   Check of serviceability of functioning of gauges CKP, CMP and detonations
   Service of spark plugs
   Check of a condition of high-voltage wires
   Charge system - the general information and safety measures
   The generator, the general information, check and service
   Removal and generator installation
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Starters Nippondenso - check and service
   Starters Mitsubishi - check and service
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


HONDA | Обзор автомобиля: https://auto-magazine.net | Источник: https://rooffing.ru
3df4be34

Engine electric equipment

The general information and safety measures

The structure of an electric equipment of the engine includes components of systems of ignition, a charge and start. Whereas the given systems have a direct bearing on engine work, they are considered separately from an other onboard electric equipment (such as alarm and lighting fires, monitors, etc.), to placing, a design and to which principles of functioning the Chapter the Onboard electric equipment is devoted).

At service of components of systems of an electric equipment it is necessary to observe special safety measures in order to avoid risk of failure of semi-conductor elements, and also for the purpose of reception prevention элеткротравм. Remember that the generator and a starter directly are connected to the battery and in case of an overload or short circuit can become a cause of the fire. Try not to suppose hits of hair and free fragments of clothes in приводной a generator belt.

Starting electric equipment service, necessarily remove a watch, rings and other metal ornaments. Even at the disconnected battery the category of condensers at casual grounding of their plugs can lead to reception of an electric shock or a strong burn.

Do not suppose polarity infringement at battery connection. In structure of such components as the generator, or electronic blocks of management enter semi-conductor elements which can be put out of action at wrong connection of wires.

At performance of start of the engine from the external power supply, or connection зарядного devices also observe polarity of connection of wires (the corresponding Section in Introduction to the present Management see).

Never disconnect electroconducting from the battery, the generator or the diagnostic equipment at the working engine.

Do not suppose проворачивания the engine of the disconnected generator.

At all do not make stock-taking of target pressure of the generator by grounding of its plugs.

Do not apply to conductivity stock-taking in a chain the ohmmeters equipped manual dynamo-car.

At performance of any works on electric equipment service watch, that the negative wire has been disconnected from the battery.

Before use of electroarc welding without fail disconnect the battery, the generator and such components, as ECM systems of a food/ignition in order to avoid risk of their damage.