Subaru Forester

1997-2005 of release

Repair and car operation

Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Removal and installation of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures
   Check of serviceability of functioning of system of ignition
   Assemblage of coils of ignition - the general information, check of a condition and replacement
   Check and adjustment of installation of a corner of an advancing of ignition
   Replacement of the module of ignition
   Check of serviceability of functioning of gauges CKP, CMP and detonations
   Service of spark plugs
   Check of a condition of high-voltage wires
   Charge system - the general information and safety measures
   The generator, the general information, check and service
   Removal and generator installation
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Starters Nippondenso - check and service
   Starters Mitsubishi - check and service
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Check and adjustment of installation of a corner of an advancing of ignition

Procedure described more low is applicable concerning the majority considered in the present Management to models. Nevertheless, in case of different interpretations with the data resulted on label VECI, should give preference the last.

Be careful, - try not to burn about hot surfaces of the heated-up engine to normal working temperature!

PERFORMANCE ORDER


1. In systems of direct ignition of installation of a corner of an advancing of ignition used on considered models can be checked up, however to adjustment are not subject. 2. At negative results of check (Specifications see) it is necessary to make testing of a control system by the engine. 3. Warm up the engine to normal working temperature. 4. Operating according to instructions of manufacturers, connect a stroboscope to ВВ to a wire of a spark plug of the first cylinder (the scheme of an arrangement of cylinders in the engine Routine maintenance see in Specifications to the Head).
5. Start the engine on single turns (tracing of frequency of rotation of the engine can be made both on built in a combination of devices, and on дистанционно connected - operate according to instructions of manufacturers - to a tachometre) and on a site of an adjusting label to a scale shined with a stroboscope define value of a corner of an advancing of ignition. Compare results of measurement to the data resulted in Specifications.