Subaru Forester

1997-2005 of release

Repair and car operation



Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
- Coupling, трансмиссионная a line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition of components and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of a drive of deenergizing of coupling
   Forward power shafts - the general information
   Removal, service and installation of forward power shafts
   Removal and installation of assemblage of a rotary fist, service ступичной assemblages
   Back power shafts - the general information
   Removal, service and installation of back power shafts
   Removal, service and installation of a back nave
   Back differential - the general information
   Removal and installation карданного a shaft
   Removal and installation of a flange of a leading gear wheel of differential and epiploon
   Removal and installation of back differential
   Differential major repairs
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
3df4be34


Removal and installation of assemblage of a rotary fist, service ступичной assemblages

Bearings and epiploons are subject to replacement without fail!

Removal

 PERFORMANCE ORDER

1. Поддомкратьте the car also establish it on props.
2. Remove a corresponding forward wheel
3. By means of a chisel расчеканьте ступичную a nut.
4. Remove from a rotary fist a support of the brake mechanism and, without disconnecting from it hydraulic шлаги, tie up a wire to suspension bracket elements.
5. Disconnect wheel gauge ABS.
6. Remove a brake disk.
7. Liberate from assemblage of a rotary fist a spherical support.
8. Take шплинт and release a nut of fastening of a tip of steering draught. By means of a stripper liberate a tip from a fist.
9. Mark head position развального a bolt, then turn out bolts of fastening of a rotary fist to a suspension bracket rack.
10. Liberate from a fist a power shaft.


Dismantling

Vypressovyvanie naves from assemblage of a rotary fist

1  —  Stupichnyj the stand (927080000)
2  — the  Special stripper (927060000)

 


 PERFORMANCE ORDER

1. Establish assemblage of a rotary fist on assembly ступичный the stand. And by means of special adaptations выпрессуйте a nave. Take an internal epiploon and a lock ring.
2. Prop up a fist and liberate from it the internal bearing.
3. Remove from a nave роторное a ring of wheel gauge ABS.
4. By means of a stripper liberate from a nave the bearing and an epiploon.


Assemblage

 PERFORMANCE ORDER

1. Establish a fist in a press and by means of the special tool (927080000) and ступичного the stand (927060000) plant in it bearings and epiploons. Track, that bearings have been properly greased, before installation of an internal epiploon do not forget to plant a lock ring.
2. At a corresponding complete set establish on a nave a rotor of wheel gauge ABS.
3. Запрессуйте a nave in assemblage of a rotary fist.


Installation

Installation is made in an order, the return to an order of dismantle of components. Track, that all fixture has been tightened with demanded effort.