Subaru Forester

1997-2005 of release

Repair and car operation

Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
- The power supply system and release
   System of release of the fulfilled gases - the general information
   Measurement of pressure of fuel
   Pressure dump in the power supply system
   Principle of action and check of serviceability of functioning of the fuel pump
   Service of the fuel filter
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Service перекидного the valve
   Removal and installation of the case of a throttle
   Injectors of injection of fuel - the general information and service
   Regulator of pressure of fuel - the general data
   Cleaning and repair of a fuel tank - the general data
   Removal and installation of the gauge of measurement of weight of air (MAF)
   Check of serviceability of functioning of system of electronic injection
   Turbo-supercharging system - the general information
   Service of system of a turbo-supercharging
   Release system - the general information
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Крыша из металочерепицы

Service перекидного the valve

Remember that gasoline is extremely an inflammable liquid!

At work with power supply system components observe all taken measures of fire safety.

Do not smoke! Do not come nearer to a place of work with open fire or the redurable not protected by a lamp shade!

Do not make system service in the premises equipped working on natural gas and heating devices equipped with a control torch (such as водогреи and dryers for clothes).

Do not forget that gasoline is among cancerogenic substances, i.e., - the substances promoting development of a cancer!

Try not to suppose fuel hit on open sites of a body, use rubber protective gloves, at casual unforeseen contact to fuel carefully wash out hands warm water with soap.

Immediately collect the spilt fuel and do not put the rags impregnated with PETROLEUM PRODUCTS near to sources of open fire.

Remember that the power supply system equipped with injection of fuel of models constantly is under pressure.
Before to start a detachment of fuel lines, dump residual pressure in system.

At service of components of the power supply system put on goggles. Constantly hold near at hand the class fire extinguisher In!

Site перекидного the valve of a fuel path

The scheme of a lining of lines and placing of components of a fuel path

1  — the  Electromagnetic valve of a purge of coal adsorber EVAP
2  —  Perekidnoj the valve
3  — the  Electromagnetic valve of management of pressure
4  — the  Socket of fast joining
5  — the  Fuel pump
6  — the  pressure Gauge in a fuel tank

7  — the  Electromagnetic valve of management of ventilation EVAP
8  — the  Air filter
9  — the  Coal adsorber
10  —  Zapornyj the fuel valve
11 — the  Fuel tank
12  — the  Fuel filter

Removal and installation


1. Поддомкратьте the car also establish it on props.
2. Disconnect fuel hoses and remove the valve from the basic arm.
3. Installation is made upside-down.



1. Remove the valve from the car (see above).
2. Connect to the valve hoses according to the scheme resulted on an illustration.
3. Blow in the open end of a hose and simultaneously incline the valve a minimum under 90 at first to the left, then to the right from normal position, - at a valve inclination in any party its passableness should be broken.
4. The faulty valve is subject to replacement.