Subaru Forester

1997-2005 of release

Repair and car operation

Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
- Brake system
   Specifications
   System of antiblocking of brakes (ABS) - the general information and diagnostic checks
   Removal and installation of basic components ABS
   Check and adjustment of height of position and free wheeling of a pedal of a foot brake
   Adjustment of a rod of pusher gtts / of the VACUUM amplifier of brakes
   Check and adjustment of a drive of a lay brake
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Replacement brake колодок disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Replacement of boots and service of drum-type brake mechanisms of back wheels
   Removal and installation of components of assemblage of a lay brake (model with disk brake mechanisms of back wheels)
   Removal and installation of the main brake cylinder
   Check of a condition and replacement of brake lines and hoses
   Removal and installation of assemblage of the vacuum amplifier of brakes
   Prorolling of brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Черный дым из выхлопной трубы причины

Check and adjustment of height of position and free wheeling of a pedal of a foot brake

Pedal height

PERFORMANCE ORDER

1. Measure height of position of a pedal of a foot brake over the floor panel. Compare result of measurement to requirements of Specifications. In case of need make corresponding updating.
2. Updating height of position of a brake is made by регулриовки a rod of a pusher of the vacuum amplifier of brakes (the Section Adjustment of a rod of pusher gtts / of the VACUUM amplifier of brakes see).

Free wheeling (люфт) pedals

Check of a free wheeling of a pedal of a foot brake


1 — the Rod of a pusher of the vacuum amplifier of brakes 2 — the Counternut 3 — the Pin 4 — Ljuft of a pin 5 — the Cutting finger 6 — Ljuft of a pedal (1 3 mm)

PERFORMANCE ORDER

1. Estimate free wheeling size (люфта) pedals of a foot brake. Compare result of measurement to requirements of Specifications. In case of need make corresponding adjustment.
2. Size adjustment люфта pedals is made by updating of position of the gauge-switch of stoplights, - do not rotate the gauge-switch. Having finished adjustment, tighten a counternut of the gauge-switch with demanded effort (6 10 Nanometers).