Subaru Forester

1997-2005 of release

Repair and car operation



Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
- Brake system
   Specifications
   System of antiblocking of brakes (ABS) - the general information and diagnostic checks
   Removal and installation of basic components ABS
   Check and adjustment of height of position and free wheeling of a pedal of a foot brake
   Adjustment of a rod of pusher gtts / of the VACUUM amplifier of brakes
   Check and adjustment of a drive of a lay brake
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Replacement brake колодок disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Replacement of boots and service of drum-type brake mechanisms of back wheels
   Removal and installation of components of assemblage of a lay brake (model with disk brake mechanisms of back wheels)
   Removal and installation of the main brake cylinder
   Check of a condition and replacement of brake lines and hoses
   Removal and installation of assemblage of the vacuum amplifier of brakes
   Prorolling of brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


правила для тонованих автомобілів
3df4be34

Check of serviceability of functioning of the vacuum amplifier of brakes

 PERFORMANCE ORDER

1. Start the engine, allow to it to work within two-three minutes, then muffle.
2. Some times squeeze out a pedal of a foot brake with normal effort, - at everyone to rolling the height of position of the squeezed out pedal should increase.
3. Keeping a pedal squeezed out, start the engine, - the pedal should fail considerably.
4. Without releasing a pedal, muffle the engine and keep a pedal squeezed out during not less than 30 seconds, - for stipulated time the height of position of a pedal should not to change. Insignificant lifting of a pedal will testify to presence of leaks in the amplifier, - check up serviceability of functioning of the control valve. If the valve is perfectly in order, replace assemblage of the servo-driver of the amplifier.