Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Specifications
Search of causes of failures of an electric equipment
Safety locks - the general information
Chain breakers - the general information
The relay - the general information and check of serviceability of functioning
System of additional safety (SRS) - the device and a functioning principle
Removal and installation of components SRS
Diagnostics of malfunctions SRS
Control system of speed (темпостат) - the device and a functioning principle
Adjustments of components темпостата
Check of serviceability of functioning of components and problem diagnostics темпостата
Removal and installation of components of a control system by speed
Heating of back glass and rear-view mirrors - the general information, check of serviceability of functioning, regenerative repair
Combination of devices - the general information, check of serviceability of functioning of components
Removal and installation of a combination of devices
The electric drive of rear-view mirrors - the general information, check of serviceability of functioning of components
Removal and installation of components of the electric drive of rear-view mirrors
The electric drive door Glass lifts - the general information, check of serviceability of functioning of components
Removal and installation of regulators Glass lifts
The uniform lock - the device and a functioning principle, diagnostics of malfunctions, check of a condition of components
Removal and installation of activators of door-locks
Switches of a steering column - the general information, check of serviceability of functioning
Removal and installation of switches of a steering column
Cleaners and washers of glasses - the general information, adjustment and check of a condition of components
Removal and installation of components of cleaners/washers of glasses
Replacement of lamps of lighting devices
The radio receiver aerial - the general information
Audiosystem - the general information
+ Schemes of electric connections - the general information
|
Removal and installation of components of a control system by speed
|
|
Models of cars considered in the present Management are equipped by system of additional safety (SRS).
Before to start performance of any works near to the block of a pillow of safety, a steering column or the instrument panel, disconnect SRS in order to avoid reception of traumas at its casual operation (the Section System of additional safety (SRS) - the device and a functioning principle see).
Electroconducting of chain SRS is easy for distinguishing on yellow colour of isolation. |
Actuation mechanism and cable of a drive throttle заслонки
|
|
|
1. Uncover the inlet pipeline. Give adjusting nuts of fastening of a cable темпостата to an arm near to the throttle case. 2. Disconnect a cable from кулачкового the lever of a drive throttle заслонки. 3. Turn out fixing bolts and remove an actuation mechanism темпостата in gathering with приводным a cable. 4. Installation is made upside-down. 5. In summary do not forget to adjust приводной a cable (the Section of Adjustment of components темпостата see).
|
|
The combined operating switch
|
|
1. The combined operating switch is fixed on a car steering wheel. 2. Switch off ignition. 3. Develop forward wheels of the car in rectilinear position. 4. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! Wait not less than 20 seconds. |
5. Make sure of switching-off SRS.
6. Remove from a steering wheel the module of a driver's pillow of safety (the Suspension bracket and a steering see the Head).
7. Disunite a contact socket of electroconducting of the module of a pillow of safety. 8. Remove from a steering wheel the switch of a sound signal. 9. Disunite contact sockets of electroconducting of a horn and the combined switch темпостата. 10. Remove the combined operating switch.
11. Installation is made upside-down. Do not forget to activate SRS (the Section System of additional safety (SRS) - the device and a functioning principle see). |
|
The main switch
|
|
|
1. Remove the left bottom section of furnish of the panel of devices. 2. Disunite a contact socket of electroconducting of the main switch темпостата. 3. Liberate the switch from the finishing panel. 4. Installation is made upside-down. |
|
The management module (ECU)
|
|
|
1. Switch off ignition. 2. Remove a forward overlay of a threshold of a driver's door. 3. Disconnect electroconducting and remove the management module темпостата. 4. Installation is made upside-down. |
|
|
|