Subaru Forester

1997-2005 of release

Repair and car operation

The uniform lock - the device and a functioning principle, diagnostics of malfunctions, check of a condition of components

Models of cars considered in the present Management are equipped by system of additional safety (SRS).

Before to start performance of any works near to the block of a pillow of safety, a steering column or the instrument panel, disconnect SRS in order to avoid reception of traumas at its casual operation (the Section System of additional safety (SRS) - the device and a functioning principle see).

Electroconducting of chain SRS is easy for distinguishing on yellow colour of isolation.

The general information

Lock-out of all doors of the car can be made simultaneously by lock-out of any of forward doors of the car from within or a key outside. Besides, possibility of unlocking/lock-out of each of back doors from within in an individual order is provided.

Diagnostics of malfunctions

Serviceability of functioning of locks of forward doors is broken at unlocking/lock-out by their key

PERFORMANCE ORDER

1. Check up serviceability of a condition of the cylinder of a door-lock.
2. Make sure that there was no detachment or jamming приводной draughts of the activator.

Serviceability of operation of locks of one or all doors is broken at activation of the lock of a forward door

PERFORMANCE ORDER

1. Check up serviceability of a condition of a corresponding safety lock.
2. Check up a condition of electroconducting and reliability of fastening of contact connections.
3. Check up serviceability of functioning of door activators and them drivers draughts.

Serviceability of operation of door-locks is broken at their activation from within the car

PERFORMANCE ORDER

1. Make sure of reliability of connection приводной draughts of the activator of the lock of a corresponding door.
2. Check up correctness of adjustment of the bottom draught, in case of need make corresponding updating.

Check

Activators of locks

PERFORMANCE ORDER

1. Switch off ignition.
2. Remove an internal upholstery of a corresponding door.
3. Disconnect from the activator of a door-lock electroconducting.
4. By means of wires-crosspieces submit pressure of the battery contact plugs of the activator.
5. If the activator does not work, try to change polarity of connection.
6. If the activator does not work at any polarity of connection, make its replacement.

Switches of door-locks

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

PERFORMANCE ORDER

1. Switch off ignition and disconnect a negative wire from the battery. Remove the panel of an internal upholstery of a corresponding door.
2. Disconnect from the switch of a door-lock electroconducting.
3. Remove the switch from the panel of an upholstery of a door.
4. By means of an ohmmeter check up conductivity distribution between switch plugs in each of its regular positions, - conductivity should take place at the drowned button of the switch and to disappear at it release.
5. Replace the faulty switch.