Subaru Forester

1997-2005 of release

Repair and car operation

Removal and installation of a cross-section beam (stretcher) of a back suspension bracket

Design of a back suspension bracket

1  — the  Rack
2  — the  Bottom saddle of a spring
3  —  Dempfer
4  — the  Screw spring
5  — the  Protective cover
6  — the  Top saddle of a spring
7  — the  Top support of a rack
8  — the  Cover of the top support of a rack
9  — the  Adapter (only for models Outback)
10  — the  Bar of the stabilizer of cross-section stability
11  —  Assembly скоба fastenings of the stabilizer of cross-section stability
12  — the  Plug of a fixing collar
13  — the  Collar of fastening of the stabilizer of cross-section stability
14  — the  Landing plug of a cross-section beam
15  — the  Back cross-section beam
16  — the  Washer

17  — the  Cup
18  —  Intensifying скоба (only for models the Sedan)
19  — the  Axial plug of fastening of the internal end of the forward cross-section lever of a suspension bracket
20  — the  Forward cross-section lever
21  — the  Axial plug of fastening of the internal end of the back cross-section lever of a suspension bracket
22  — the  Back cross-section lever
23  — the  Rack of the stabilizer of cross-section stability
24  — the  Axial plug of fastening of the external end of the back cross-section lever of a suspension bracket
25  — the  Axial plug of fastening of the external end of the forward cross-section lever of a suspension bracket
26  — the  Back axial plug of fastening of the longitudinal lever of a suspension bracket
27  — the  Longitudinal lever of a suspension bracket
28  — the  Forward axial plug of fastening of the longitudinal lever
29  — the  Basic arm of fastening of the forward end of the longitudinal lever

PERFORMANCE ORDER

1. Поддомкратьте the car also establish it on props.
2. Remove assemblage of back differential (Coupling, трансмиссионная a line see the Head).
3. Чертилкой mark position эксцентриковых adjusting bolts of cross-section levers of a suspension bracket concerning a stretcher.
4. Отболтите from a stretcher forward and back cross-section levers.
5. Prop up a suspension bracket beam трансмиссионным a jack.
6. Turn out fixing bolts and remove a beam.
7. Installation is made upside-down.

The definitive tightening of bolts of fastening of cross-section levers is made after car lowering on the earth. Track correctness of combination of the landing labels put in the course of dismantle. All fixture tighten with demanded effort.