Subaru Forester

1. Поддомкратьте the car also establish it on props. Remove back wheels.
2. Give ступичную a nut.
3. Release an adjusting nut of the lever of a drive of a lay brake.
4. Remove with ступичной assemblages a support and a disk of the brake mechanism (model with disk brake mechanisms of back wheels).
5. Remove a brake drum and disconnect a brake line from the wheel cylinder (model with drum-type brake mechanisms of back wheels).
6. Disconnect a cable of a drive of a lay brake.
7. Disconnect a bar of the stabilizer of cross-section stability from the back cross-section lever of a suspension bracket.
8. Turn out bolts of fastening of cross-section levers to ступичной to assemblage.
9. Turn out a fastening bolt to ступичной to assemblage of the longitudinal lever of a suspension bracket.
10. At a corresponding complete set of the car remove wheel gauge ABS.
11. Remove a spring lock ring of fastening of a semiaxis to differential.
12. Remove полуось.
13. Separate ступичную assemblage from a suspension bracket rack.
14. Remove a brake board.
15. Remove epiploons and a lock ring.
16. For bearing removal take advantage of the stand (927430000) and a stripper (927440000).
17. Remove a casing ступичной assemblages, transfer it on the assembly stand (927080000) and by means of a stripper (927420000) dismantle a nave.

1. Remove dust from a casing ступичной assemblages.
2. By means of the stand (927430000) and оправки (927460000) establish an internal epiploon ступичной assemblages, - the epiploon refuels against the stop in a bottom of a landing nest.
3. Establish an additional epiploon, - it is necessary to grease sponges of epiploons with type greasing № 6459.
4. Establish a brake board.
5. For landing in a bearing nave take advantage of the stand (927080000) and оправкой (927450000).
6. The further installation is made in an order, the return to an order of dismantle of components.