| 1. Поддомкратьте the car also establish it on props.
2. Remove the stabilizer of cross-section stability (see Has undressed Removal and installation of the forward stabilizer of cross-section stability) and поддомкратную a plate.
3. Remove from the bottom lever of a suspension bracket a basic arm of a cable of a drive of a lay brake.
4. Disconnect steering draughts from rotary fists.
5. Remove a reception pipe of system of release of the fulfilled gases (see the Head of the Power supply system and release).
6. Disconnect from a cross-section beam the bottom levers of a suspension bracket.
7. Give fastening nuts to a cross-section beam of a support of a suspension bracket of the power unit.
8. Give nuts of fastening of a twisting rod and a shaft of a drive of the steering mechanism.
9. Hang out the power unit, having raised it over a suspension bracket beam approximately on 10 mm.
10. Prop up a beam a jack.
11. Give fixing beams and remove a beam in gathering with реечной transfer.
12. Installation is made upside-down. A definitive tightening of nuts of fastening of a beam, and also fastening bolts to it of the bottom levers of a suspension bracket it is necessary to make the earth after lowering of the car. Track, that all fixture has been tightened with demanded effort. |
