Subaru Forester

1997-2005 of release

Repair and car operation

Removal and installation of the bottom lever of a forward suspension bracket from a spherical support

Removal

Design of a forward suspension bracket

1  — the  Cross-section beam of a suspension bracket
2  — the  Bar of the stabilizer of cross-section stability
3  — the  Rotary fist
4  — the  Back axial plug of fastening of the bottom operating lever of a suspension bracket
5  — the  Forward axial plug of fastening of the bottom operating lever of a suspension bracket
6  — the  Bottom operating lever of a suspension bracket
7  — the  Bottom spherical support
8  — the  Plug of fastening of the stabilizer of cross-section stability
9  — the  Rack of the stabilizer of cross-section stability

10  — the  Top support of a rack
11  — the  Remote washer
12  — the  Top plate of a spring
13  — the  Rubber saddle of a spring
14  — the  Protective cover
15  —  Dempfer
16  — the  Screw spring
17  —  Stojka Mak Fersona

PERFORMANCE ORDER

1. Поддомкратьте the car also establish it on props. Remove forward wheels.
2. Disconnect a bar of the stabilizer of cross-section stability from the corresponding bottom lever of a suspension bracket.
3. Turn out a coupling bolt of the bottom spherical support and liberate last from assemblage of a rotary fist.
4. Turn out a fixing bolt and separate the bottom lever from a suspension bracket beam.
5. Give a nut of fastening of the back end of the lever in fixed on the bottom of the car to the axial plug.
6. Using as the lever the big screw-driver, cautiously take away outside a rotary fist, - do not suppose extension of a protective cover of the SHRUS more than on 4 mm, - and take the bottom lever from under the car.
7. In case of need give a fixing nut and remove from the bottom lever a spherical support.

Installation

Installation is made upside-down. Before installation attentively study a condition of rubber plugs, - defective components replace. To replacement are subject also all шплинты.

The definitive tightening of a bolt of fastening of the bottom lever to a suspension bracket beam is made after car lowering on the earth! Track, that all fixture has been tightened with demanded effort.