Subaru Forester
+ Cars Subaru Forester
+ The maintenance instruction
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Gear change box
+ Coupling, трансмиссионная a line
+ Brake system
- Suspension bracket and steering
Specifications
Check of a condition of spherical support of a forward suspension bracket
Check of a condition of forward wheel bearings
Removal and installation of a cross-section beam of a forward suspension bracket
Removal and installation of a rotary fist from the wheel bearing, service ступичной assemblages
Removal and installation of the bottom lever of a forward suspension bracket from a spherical support
Service of racks of a forward suspension bracket
Removal and installation of the forward stabilizer of cross-section stability
Check of a condition of back wheel bearings
Removal and installation of a cross-section beam (stretcher) of a back suspension bracket
Removal, service and installation of racks of a back suspension bracket
Removal and installation of back wheel bearings
Prorolling of a hydraulic path of a steering drive
Adjustment люфта gearings реечной transfers
Check of the pressure head characteristic of the steering pump
Check of effort of rotation of the steering mechanism
Removal and installation of the steering pump
Removal and installation of the steering mechanism
Major repairs of the steering pump
Major repairs of the steering mechanism
Steering column, - the general information, safety measures
Removal and installation of the module of a pillow of safety
Removal and steering wheel installation
Removal and installation of assemblage combined подрулевых switches
Removal and installation of the lock of ignition/blocking of a steering column
Removal and installation of a steering column
Major repairs of a steering column
Wheels and tyres - the general information
Adjustment of geometry of a suspension bracket
+ Body
+ Onboard electric equipment
|
Check of effort of rotation of the steering mechanism
|
|
|
|
1. Tyre out the car on an equal horizontal platform with a concrete covering, leave the engine working on single turns.
2. Effort check проворачивания a steering wheel is made by means of a spring dynamometer (steelyard). The result of measurement should not exceed value 3 кГс in both directions of rotation.
3. Repeat measurement at the muffled engine, - the effort проворачивания should increase approximately in 10 times (no more than 30 кГс).
4. In case of negative results of checks it is necessary to make adjustment люфта gearings реечной transfers (the Section Adjustment люфта gearings реечной transfers see).
5. If adjustment реечной transfers does not lead to situation correction (by results of repeated check), disconnect карданный the hinge from a steering column, - now the effort проворачивания should make no more than 0.23 кГс, otherwise it is necessary to check up a condition and reliability of fastening of tips of steering draughts and spherical support of a suspension bracket. Make sure also that it is not jammed карданный the hinge. |
| 6. Remove assemblage of the steering mechanism (see Has undressed Removal and installation of the steering mechanism) and measure effort проворачивания its entrance shaft at disconnected карданном the hinge. The result of measurement should not make more than 1.3 кГс. |
|
| 7. Remove internal tips of steering draughts and by means of a spring dynamometer measure resistance of sliding рейки. The result of measurement should not exceed value in 31 кГс, and the difference between measurements at вытягивании рейки divergently also should not leave for a limit in 20 %. |
|
|
|
